|
|
|
1. Turn the power switch off
|
|
2. Disconnect incline motor wiring from controller.
|
|
3. If possible, fold the machine up.
|
|
4. Turn the treadmill onto its side. (This is to take the pressure off of the
rack)
|
|
5. Remove bolt from incline tube on the bottom side of the
treadmill.
|
|
6. Remove bolt from the top of the incline motor and remove the
motor.
|
|
7. Install new motor and insert bolt at the top of the incline
motor.
|
|
8. Reconnect motor wires to controller.
|
|
9. Turn power switch on and insert tether cord. The motor will turn until it is a its
|
|
“zero” position and then stop.
|
|
10. Insert bolt into the incline tube on the bottom side of
treadmill.
|
|
11. Turn treadmill back upright and calibrate.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Top motor bolt Incline tube bolt
|
Rohit Kumar
8802959961
